본문 바로가기

Flying Floor

Flying Floor

The Flying Floor is used to conduct tests according to FMVSS 214, 201 and EURO-NCAP. The mobile platform is designed in a way that allows driving the test vehicles against a fixed barrier at any desired angle.                       The platform‘s basic frame consists of two symmetrical steel tube joist frames and two guide units. The inspe-ction area contains an acrylic glass sheet that is screwed into the basic frame and is covered with a polycarbo-nate plate. This renders the inspection area very stiff and less susceptible to wear and tear. The remaining platform area contains screwed-in multi-layer plates, which in turn are covered by PTFE plates. All PTFE plates are grounded on the frame in order to dissipate the electrostatic charge. For the braking system you can choose  between two solutions: Hydraulic dampers or buckling tubes ERNST will evaluate your customized solution af-ter an intensive analysis of your current test situation.

Technical data(Standard size, can be customized)

Length: 5000mm

Width: 6000mm

Height: 175mm

Ground clearance: 48mm

Inspection area: 2000 x 3000mm

 

Weight: 2100kg

Max.load: 4500kg*

Max.test speed: 64kph**

*Depends on test speed

**Depends on mass of the test vehicle and the track condition

첨부파일

공유하기


맨 위로 이동